,
Danger of injury!
All electrical work should be
undertaken by a suitably qualified
and competent person.
Installation, repairs and other work
by unqualified persons could be
dangerous. Miele cannot be held
liable for unauthorised work.
Ensure power is not supplied to the
appliance until after installation or
repair work has been carried out.
Connection of this appliance should
comply with national and local safety
regulations.
Connection to a switched socket
is
recommended as this provides easier
access and isolation in the case of a
service call.
If the switch is not accessible after
installation or the appliance is
hard-wired
(depending on country), an
additional means of disconnection must
be provided for all poles.
When switched off there must be an
all-pole contact gap of 3 mm in the
isolator switch (including switch, fuses
and relays according to EN 60335).
Connection data
The required connection data can be
found on the data plate located on the
oven frame visible when the door is
open.
Please ensure this information matches
the household mains supply.
When contacting Miele, please quote
the following:
– model number,
– serial number,
– connection data
(voltage/frequency/maximum rated
load).
When replacing the connection
cable supplied with another cable,
or changing the connection, only
cable type H 05 VV-F with a suitable
cross-sectional area (CSA) may be
used (available from Miele).
Electrical connection
144
Summary of Contents for H6890BP
Page 21: ...aOn Off sensor K bDisplay c I N sensors Oven controls 21 ...
Page 153: ...153 ...
Page 154: ...154 ...
