Before using for the first time
22
Filling the salt reservoir
Before filling the salt reservoir for the
first time, you must fill it with approx.
2 l of water to enable the salt to dis-
solve.
Once the dishwasher has been used
once, there is always sufficient water
in the salt reservoir.
Remove the lower basket from the
wash cabinet and unscrew the salt
reservoir cap.
Danger of corrosion due to saline
solution.
Water or saline solution will run out
of the reservoir when the cap is
opened. Saline solution that runs out
can cause corrosion in the wash
cabinet and to the dishwasher load.
The salt reservoir should therefore
only be opened in order to replenish
the salt.
Fill the salt reservoir with approx. 2 l
of water (first use only).
Place the funnel provided over the
salt reservoir and carefully fill with
dishwasher salt until the reservoir is
full. The salt reservoir holds up to
2 kg of salt, depending on the type of
salt used.
Clean off salt residues from around
the salt reservoir opening. Next,
screw the salt reservoir cap on again
firmly.
Immediately after filling the salt reser-
voir and each time you remove the
salt container cap, run the
65 °C
QuickPowerWash
pro-
gramme with the
Express
pro-
gramme option selected without a
load in the dishwasher to dissolve
and remove any traces of salt from
the wash cabinet.
Summary of Contents for G 5260
