Installation
*
I
N
S
T
A
L
L
A
T
I
O
N
*
142
Installation
The Dialog oven must not be
operated until it has been correctly
installed in its housing unit.
The Dialog oven requires a sufficient
supply of cool air for efficient
operation. The required supply of
cool air must not be excessively
heated by other heat sources (e.g.
solid fuel stoves).
The following must be observed
when installing the appliance:
Do not fit a back panel in the housing
unit.
Ensure that the interim shelf that the
Dialog oven sits on does not touch
the wall.
Do not fit heat insulation strips to the
side walls of the housing unit.
Before installation
Ensure that there is no power to the
mains socket.
Installing the Dialog oven
Connect the Dialog oven to the
electrical supply.
Lifting the Dialog oven by the door
handle could cause damage to the
door.
Use the handle cut-outs on the side
of the casing to lift the appliance.
Push the Dialog oven into the housing
unit and align it.
Open the door.
Pull the water intake pipe forwards
(located below the control panel on
the left).
Secure the Dialog oven to the side
walls of the housing unit using the
screws supplied.
