Problem solving guide
163
Problem
Cause and remedy
After moving house the
appliance no longer
switches from the heat‐
ing-up phase to the
cooking phase.
The boiling temperature of the water has changed as
the altitude of the new location for the appliance dif‐
fers from the old one by at least 300 m.
To adjust the boiling temperature, you need to
descale the appliance (see "Cleaning and care -
Descaling").
During operation an un‐
usually large amount of
steam escapes, or
steam escapes from
parts of the oven where
it does not usually.
The door is not properly closed.
Close the door.
The door seal is not correctly fitted.
Press it in all the way round the door to make sure
it is fitted evenly.
The door seal is damaged, e.g. cracks can be seen.
Replace the door seal.
This can be ordered from Miele (see the end of
this booklet for contact details).
The control panel will
not open or close auto‐
matically despite touch‐
ing the
sensor sever‐
al times.
Something is obstructing the control panel.
Remove the obstruction.
The obstruction sensor is very sensitive and can pre‐
vent the panel opening or shutting if it picks up a sig‐
nal.
Open/close the control panel manually (see end of
this section)
If the problem occurs again, contact Miele Serv‐
ice.
The oven interior light‐
ing is not working.
The lamp is defective.
Call Miele Service to have the lamp replaced.
The
Start at
and
Ready at
functions have not
worked.
The temperature in the oven is too high, e.g. after a
programme has finished.
Open the door and let the oven cool down.
These functions are not available with
Menu cooking
and
Maintenance
.
Summary of Contents for DGC 6860
Page 68: ...Minute minder Alarm 68 Confirm with OK ...
Page 186: ......
Page 188: ...M Nr 10 348 120 00 en GB DGC 6860 ...