,
CAUTION:
Before installation or
servicing, disconnect the power
supply by either removing the fuse,
shutting off the main power or
manually "tripping" the circuit
breaker.
Installation work and repairs should
only be performed by a qualified
technician in accordance with all
applicable codes and standards.
Repairs and service by unqualified
persons could be dangerous.
Before connecting the appliance to
the power supply, make sure that
the voltage and frequency listed on
the rating label correspond with the
household electrical supply. This
data must correspond to prevent
appliance damage.
Only operate the appliance after it
has been installed.
If there is any question concerning
the electrical connection of this
appliance to your power supply,
please consult a licensed electrician
or contact Miele’s Technical Service
Department.
Installer:
Please leave these instructions with
the consumer.
Power supply
Installation, repairs and other work
by unqualified persons could be
dangerous.
^
Be sure your electrical supply
matches the data plate.
The appliance is equipped with a 5 ft.
(1.5 m) flexible power cord encasing 3
wires ready for hardwiring to a 240 V,
20 A, 60 Hz grounded power supply.
It must be connected to a dedicated
line through the use of an approved
junction box.
A disconnection incorporated in the
fixed wiring must be provided. There
must be an all-pole contact gap of at
least 3 mm in the isolator switch
(including switch, fuses and relays).
Black wire: connect to L1 (hot)
Red wire: connect to L2 (hot)
Green wire: connect to GND (ground)
For further information, see the wiring
diagram provided with the appliance.
,
WARNING:
THIS APPLIANCE MUST BE
GROUNDED!
Technical Data
70
Summary of Contents for DGC 4084 XL
Page 8: ...Guide to the appliance 8 l n m o a b c e h f i j e g d k Clear Timer Lift Panel On Off ...
Page 73: ...73 ...
Page 74: ...74 ...
Page 75: ...75 ...