en - Installation
54
Secure the holder in the module
Tools required:
– Spanner, 9 mm (SW 9)
A 805, A 806
A 807
The hose for the rinse
attachment at the upper end of
the casing must be connected
to the module water inlet pipe.
A special hose adapter is
required for the rinse connection
on the shaft of the stapler or
instrument. This must also be
connected to the water inlet
pipe.
The two hoses for the rinse
attachments at the upper end of
the casing of the PK™
Dissecting Forceps must be
connected to the module water
inlet pipe.
Two notches are located on the cross rail of the module to which the
holders can be secured.
Push the holder onto one of the notches on the module until it
clicks into place.
Remove the caps from the front side of the water inlet pipe.
Screw the hoses from the holder and the hose adapter (if present)
to the water inlet pipe.
Summary of Contents for A 600
Page 2: ...2 de 4 da 22 en 39 es 56 fi 74 fr 91 it 109 nl 128 no 146 pt 163 sv 181 ...
Page 197: ......
Page 198: ......
Page 199: ......
