en - Areas of application
39
Flasks and round flasks
Installing A 846
for flasks and
round flasks
Adjust the height of the frame.
- Flasks:
The height of the frame should be adjusted so that it comes to ap-
proximately halfway up the flasks.
- Round flasks:
The height of the frame should be adjusted so that it is approxim-
ately at the point of the largest diameter on the round flasks.
Remove one of the knurled nuts out of the module’s injector rails.
Place the support for the A 846 on the threaded fitting and screw
the injector nozzle in
.
Use a 17 mm spanner (WAF 17) to tighten the injector nozzle
.
Place the rods on the frame above the injector nozzle.
Secure the rods on the right and left using the module’s retaining
bars.
The distances between the rods and the retaining bars must be
roughly equal to the diameter of the load items.
