Use
16
Danger of burning on the hot edge of the heater plate.
When the rotary iron has heated up, there is a danger of burns on
the edge of the heater plate. Warning labels on the outer casing of
the heater plate indicate the danger of burns.
Avoiding touching the edges of the heater plate.
Wait until the selected temperature has been reached.
The
button begins to flash as soon as the minimum temperature
has been reached.
The rotary iron is ready for operation when the set temperature is
reached and the
symbol no longer appears in the display.
Now press the flashing
button to start up the iron.
The rotary iron is now ready for use.
Ironing
Ironing tempera-
ture
The ironing temperature should be selected according to the type of
fabric being ironed.
Type of fabric
Symbol
Temperature
Preset value
Nylon/artificial silk
212-230°F (100–
110°C)
230°F (110°C)
Woolens/silk
231-302°F (111–
150°C)
257°F (125°C)
Cotton/linen
303-365°F (151–
185°C)
180°F (356°C)
Temperature selection buttons
The temperature of the rotary iron can be set either via the tempera-
ture selection buttons (
/
/
) or alternatively via the
or
–
but-
tons.
When adjusting the rotary iron from a higher ironing temperature to a
lower ironing temperature, the heater plate must cool down first. In
this case, the rotary iron’s heater element is switched off. The red
symbol indicates that the current temperature of the rotary iron is
still too high. When the
symbol goes out, this indicates that the se-
lected temperature has been reached.
Setting the iron-
ing temperature
Press the
button on the control panel to access the ironing
temperature selection mode.
The
button will then be highlighted with a bar underneath.
Now press one of the three temperature selection buttons.
