Before use
Before the appliance is used for the first
time, the Miele approved service
technician will need to install the
correct hardness range disk (Meter
Disk) for the water hardness level in
your area.
^
Find out the mains water hardness
level in your area.
^
Please make a note of the water
hardness level here.
Hardness level:
The service technician will connect the
Aqua-Soft-System to the water supply,
fill the resin cartridges and start the
system. The built-in salt valve limits the
amount of water going into and out of
the unit by means of a float switch to
ensure there is sufficient salt available
for reactivation.
It is important to use good quality
reactivation salt. Only use salt tablets or
coarse grained reactivation salt
(8 - 15 mm grain).
Only use reactivation salt that is suit-
able for water softeners.
Never use cooking salt, as it contains
particles which do not dissolve in water.
These particles can cause a blockage
in the Aqua-Soft-System.
Filling the salt container
^
Remove the lid.
^
Fill the salt container with reactivation
salt or salt tablets.
Capacity:
20 kg
First fill:
20 kg
^
Replace the lid.
To keep evaporation to a minimum
make sure that the lid is always
replaced securely in position.
The Aqua-Soft-System is now ready for
operation and will deliver softened
water.
Please contact the Miele Service
Department if in any doubt.
en - Operation
15
