ROOF CUPOLA
1) Slide the four corner poStS
trim on the Side aSSemblieS.
1) attach roof cap and bottom
plate to one roof Section with
#14×1" tech ScrewS.
(finger tight at thiS point)
2) Slide the roof SectionS into the
roof connecting flange of each
Side aSSembly. the top of each
roof Section SlideS between the
roof cap and bottom plate and iS
faStened in place.
3) Slide each roof connector
4-5" at a time until all of the
connectorS are under the
roof cap.
2) once all four SideS are connected,
turn the baSe over So the roof
connecting flange iS up.
roof aSSembly
baSe aSSembly
corner post trim
roof connecting
flange
roof
Section
roof
cap
roof connectors
4) after all of the roof
connectorS are driven
under the roof cap,
tighten the tech
ScrewS and trim the
roof connectorS off
to create a finiShed
appearance.
