Midland G5 C, User Manual

Page: 37 / 135

Midland G5 C user manual | 7
19 corresponds to channel 05 31
20 corresponds to channel 07 31
21 corresponds to channel 02 31
22 corresponds to channel 04 31
23 corresponds to channel 06 31
24 corresponds to channel 08 31
For displaying the channel/sub audio tone
To momentarily display the PMR446 channel and the subadio tone used in the
pre-set channels, go to the desired channel (from 9 to 24) and keep pressed
the buttons ▲▼ for 5 seconds.
Transmission and reception
To communicate, all radios in your group must be set on the same channel.
To transmit, press and hold the PTT button and speak in a normal voice into
the microphone. The “TX” icon will appear continuously on the LCD display
while transmitting.
You can communicate also using an external accessory or a hand mic, pressing
and holding the PTT button on the side of the hand mic.
To receive a CALL, release the PTT button. The “RX” icon will appear on the
display when your radio is receiving a transmission.
Squelch
In MIDLAND G5 C the squelch (filter to suppress noises) is always active.
Monitor
Press MODE and / at the same time to open the squelch and allow the
reception of weak signals.
Keypad Lock
Keep pressed the button / for about 5 seconds and the lock function will be
activated. “Lc on” will appear on the display. To disable this function, keep pres-
sed again the button / for 5 seconds approx. The display will show “Lc of” .