MIDIPLUS Co, Ltd. http://www.midiplus.com.tw
display: “t” for drum tempo and then the number, e.g. t.112
5.10
- in drum-mode this button controls the 10 step up
display: “L” for the volume level and then the number, e.g. L.127
6.Preset -1
– this button switches the drum pattern program number in one
step down
display: “d” for drum and then the program-number, e.g. d.000
7.Channel
– in drum-mode this button can not choose midi channel.
8.RevD
– with this button you can choose a reverb type parameter.
display: “e” for the effect power from 0-127, e.g. e.110
9.Tempo -1
- in drum-mode this button controls the tempo of the pattern in 1
step down
display: “t” for drum tempo and then the number, e.g. t.112
10.Volume -10
- in drum-mode this button controls the volume -10 step down
display: “L” for the volume level and then the number, e.g. L.127
7.Save
and Reset , Panic function
Save function
: Hold down the
“
Select Bank
” button for 3 seconds to save
your settings data, LED display
“SAVE”.
Reset function
: Hold down the
“
Drum/Sound
” button for 3 seconds to reset
the factory parameters, LED display
“AESE”.
Panic function
: Hold down the
“
RevT
” and“
RevD
” button for 3 seconds to
enable Panic function, LED display
“P.OFF”, it close the residual MIDI note.
8. Afterword.
Because the S-Engine is fully 8030 GM/EMU compatible, you can send
normal GM/EMU bank select and program change orders with a sequencer ,a
master keyboard or computer. So you will reach the additional sounds and
drum sets. The drum sounds are only triggered on MIDI channel 10.
Note
：
Shake the S-Engine machine to make a noise, it is the
noise of the aluminum button on the panel, it is not the
component loose inside the machine, not the quality problem.
