Flush installation
Flush installation also requires:
▯
two side cleats to be attached inside the cabinet
frame, recessed from the front
▯
a
5
/
16
" (8 mm) baseplate underneath the unit body.
Electrical Installation
The model stated on the front cover is rated at 120V AC,
60 Hz and uses a NEMA 5-20 plug to connect to a
dedicated 120 V microwave circuit.
Electrical Requirements:
▯
a three prong grounded outlet
▯
120 V, 60 Hz, AC only
▯
20 Amp electrical supply with a fuse or a circuit
breaker
This product must be connected to a supply circuit of the
proper voltage and frequency. Wire size must conform to
the requirements of the National Electric Code or the
prevailing local code for this rating. The power supply
cord and plug should be brought to a separate 20-amp
branch circuit single grounded outlet. The outlet box
should be located inside the cabinet above the appliance
(see section
Location Requirements
). The outlet box and
supply circuit should be installed by a qualified
electrician and conform to the National Electrical Code or
the prevailing local code.
The voltage used must be the same as specified on this
microwave oven. Using a higher voltage is dangerous
and may result in a fire or oven damage. Using a lower
voltage will cause slow cooking. The dealer is not
responsible for any damages resulting from the use of
the oven with any voltage other than specified.
Install Appliance
Note:
The appliance is heavy. It is advisable to install it
with a second person.
NOTICE:
Before installing the appliance, be sure to
verify the cabinet dimensions and electrical connections.
Mount to Cabinet
1.
Fully insert the appliance and center it. Do not kink the
electrical cable.
2.
Screw the appliance into place.
PHDVXUHPHQWVLQLQFKHVPP
7RSYLHZ
6LGHYLHZ
ê
)OXVKLQVHW
GHSWK
ë
&OHDWV
&OHDWV
è¼ʓʘ
FOHDWV
ê
ë
RSHQLQJ
FXWRXW
KHLJKW
ʎ¼ʓʘ
IOXVK
FXWRXW
KHLJKW
EDVHSODWH
ʌ¼ʓʘ
èç¼ʓʘ
ë
èç¼ʓʘ
Model
Connection
Circuit
Requirements
HMC84252UC
NEMA 5-20
120 V,
60 Hz
20 Amps
7
Summary of Contents for TF044EYY-SH0D
Page 23: ...25...
