Micsig Smart Series, User Manual

Page: 228 / 354

214
12.1 UART (RS232/RS422/RS485) Bus Trigger and Decode
For correctly decoding UART(RS232/RS422/RS485) bus data and making trigger stable, the bus configuration,
trigger mode setting and trigger level need to be adjusted.
⚫ Bus configuration
Tap or to open the bus configuration menu, as shown in Figure 12-4. The RX channel must be
chosen and the following parameters must be set according to measured signals:
Idle Level — Choose Idle Low or Idle High to match the idle state of measured equipment. For RS232, Idle
Low may be chosen.
Note: RS232 industry standard uses “negative logic”, namely high level is logic “0” and low level is logic
“1”.
Parity Bit — Choose odd, even or none depending on measured equipment.
Word Length — Set the number of bits in UART word to match measured equipment (5-9 bits available).