3-3
© Copyright 2006 Microwave Data Systems Inc. All Rights Reserved
User Interface Manual
MDS FIVE Series
05-4574A01, Rev. C
Figure 3-3. CLI menu type screens.
3.1.2.2 Configurable Screens
Configurable screens are used to set various parameters. Figure 3-4 shows the
“General Network Configuration” screen, which is an example of a configurable
screen. Parameters are listed with their values and a “hotkey.” Press the “hotkey”
to configure the corresponding parameter. For example, enter ‘a’ / ‘A’, to edit IP
address, then press “Enter Key”. Some parameters may have a set list of values.
For example, the DHCP Client parameter has two values: Enabled and Disable.
To edit this type of parameter, press the corresponding “hotkey” (in this case “E”),
then press the “Space Bar”-key, to scroll through different values. Once the
desired value is displayed, press the “Enter”-key. If the parameter is displayed
without a “hotkey,” it indicates a read-only parameter.
Note
Further references to “hotkey” in this document will refer to the
character encapsulated in [ ] brackets for the individual parameter.
