Installer Manual
Microvideo srl
www.microvideo.eu
54
CHAPTER 4– Programming Control Panel
Alarm Management
Parameter
Options
Description
AlarmStop Allarme
---
All alarm cycles relative to the outputs are stopped
AlarmMemClear
---
All alarm LEDs of all the keyboards in the plant are OFF
CallsClear
---
Call queue from GSM is cleared
System Management
Parameter
Options
Description
Events LOG
---
It displays all LOGs di stored in the control unit; the top line of the display shows the date and time at
which it was recorded the event, the bottom line of the display shows the description of the event.
Use Navigation arrows to skip to the previous or next LOG
ArmDisarm LOG
---
It displays only LOGs relative to arming and disarming of areas
Alarms LOG
---
It displays only LOGs relative to alarms of zones and areas
SatFail LOG
---
It displays only LOGs relative to TAMPER or failure of modules or zones in the System
LoginLogout LOG
---
It displays only LOGs relative to access by Codes or RFID keys
Default Rest.
---
Restores Default Setup
TeleAssistance
---
It commands to GSM module to connect to Internet, once the connection is established Display
shows IP address for the installer for Remote assistance procedure
DayTime Config
DateCfg.
(gg/mm/aa)
Allows you to change the current date, to switch the selection between fields "day", "month", "year"
using the special "FN" key and arrow keys to edit the value of the selected field
TimeCfg.
(00:00...23:59)
Allows you to change the current time, to switch the selection between fields "hour" and "minute"
using the special "FN" key and arrow keys to edit the value of the selected field
DayCfg.
(Monday...Sunday)
Allows you to change the current day of week
Buzz Volume
(1...4)
Setting up the Audio Volume BUZZER ofKeyboard
Audio Volume
(0...4)
Configuring the Audio Volume of Keyboard
Zone Status
Only Read
(Zone1...Zone73)
(RadioZone1...RadioZ
one64)
Displays Real Time Staus of Zones, the possible states are:
- Disabled
- Rest
- Alarm
- Sat / Fault
- Tamper
- Masking
Diagnostics
Only Read
It displays diagnostic alarms in progress. Displays an alarm at a time, once corrected the alarm on
display, it shows the next alarm and so on. N.B. You can access this menu directly from the main
menu pressing FN +9
Firmware Ver.
Only Read
Displays Firmware version of all plant modules
Enable Installer
Yes
Installer codes enabled
NO
Installer codes disabled
Fog Maker Service
Reset Sign.
It allows you to reset some of fog failure Reports.
Liquid Level
It allows you to see liquid quantity that was entered into the tank at the moment of charging.
FogMonitor
Allows real time monitoring of values of temperature (indicated by the letter T) and Liquid Level
(indicated by the letter L) of the fog machine.
Install Menu
26)
Alarm Management
Alarm Management
Stop Alarm
OK
Install Menu
27)
SystemManagement
SystemManagement
Events Log
OK
Summary of Contents for Synergy SY800
Page 1: ...1 ...
Page 60: ...Installer Manual Microvideo srl www microvideo eu 60 ...
