Microvideo Synergy SY800, Instruction Manual

Page: 50 / 69

Installer Manual Microvideo srl www.microvideo.eu
50 CHAPTER 4– Programming Control Panel
Actions
Parameter Options Description
Description 12 characters
Action description. Description appears during configuration, either by keyboard then by
SynergyPro SW, in every log, and in SMS messages relative to action
Type
NoConfig Action not Configured
Output active Inverts Default Satus of Output
Output Disabled Output Back to Default Status
Keyboard Buzzer Keyboard Buzzer Active
Send SMS Sends SMS
Vocal Call Sends a vocal call
TLV Message Sends a Call to TLV
Alarms stop All Outputs back to Default Status
Phone Calls Erase Stops Actual calls and deletes Call Queue
AlarmMem Erase All keyboards Leds, indicating Alarm memory, OFF
Area Arm Area ared
Area Disarm Area disarmed
DVR WALL ON Sends PowerON command to WALL module
DVR WALL OFF Sends PowerOFF command to WALL module
Fog machine shot active Sends Shot command to FOG module
Element ID
(All elements,
NoConfig,Element1..Element64)
Element to which Action Type refers
Activat.Time (0...600) Time (sec.) of Action executing
Activat.Cycles (0...20) Action Executing Cycles
Delay Time (0...600) Delay Time (secondi) of executing action
Events
Events are messages triggered when "something" happens in the system. Each event can
be associated with an initial macro, namely a macro that is executed when the event
occurs, and a final macro that runs when you restore the conditions before the event.
For example, if we consider the event "No 220 network", the initial macro is executed
when there is a lack of power supply, while the final macro (reset) is performed when the
line voltage returns to be correct.
the events
Programmable Events
Parameter Options Description
Type
No Config. Not configured event
Zone Alarm Event on Zone Alarm/rest
AreaStatusChange Event on Area Armed/Disarmed
TimerStatusChange Event on Start/End Timer Bands
Code Inser. Event on valid Login Code
Key Touch on Event on Valid authentication key
Area Alarm Event on Area Alarm/Rest
Zone diagnostics Event on Recovery after Tamper or recovery after Fault of the Zone
Alarm of Zone Checkup
Event on Alarm/Restore Zone Checkup: In a zone a checkup zones occurs when for a specific time (given
in general parameters), in NOT armed Status, NEVER changes its Status
Element
(All elements,
NoConfig,Elemento1..Elemento64)
Element to which refers Event Type
StartEvMacro (NoConfig,Macro1..Macro36) Macro Configuration to execute at the start of event
OK
OK Install Menu
20)Actions
Actions
Action 1
Action 1
Description
OK
Install Menu
21)Events
Events
Prog. Events
OK OK
Prog. Events
Event 1
Event 1
Type