Installer Manual
Microvideo srl
www.microvideo.eu
48
CHAPTER 4– Programming Control Panel
Radio Modules
Parameter
Options
Description
Enabled
YES
Radio Module enabled
NO
Radio Module disabled
Description
20 caratteri
Description of Radio Module. Description appears during configuration, either by keyboard then by SynergyPro SW, in
every log, and in SMS messages relative to Radio Module
Serial Number
---
Univocal serial number of the radio module. This Serial is essential for the proper function the Control panel as it rejects the
messages that come from a radio module with a serial NOT present In its program
Radio Remote Controls
Parameter
Options
Description
Inabled
YES
Radio Remote Control Enabled
NO
Radio Remote Control Disabled
Description
12 characters
Description of Radio Remote Control. Description appears during configuration, either by keyboard then by
SynergyPro SW, in every log, and in SMS messages relative to Radio Remote Control
Serial Number
---
Univocal serial number of radio remote control. This Serial is essential to the proper functioning the Control
panel as it discards messages coming from a radio remote control with a serial NOT present In its program
Timer
(NoConfig,Timer1...Timer25)
Setting of the timer to be associated with Radio remote control
Red KeyMacro
(NoConfig,Macro1..Macro36)
Setting of the macro to be associated with red key of Remote Control
GreenKeyMacro (NoConfig,Macro1..Macro36)
Setting of the macro to be associated with verde key of Remote Control
BlueKey1Macro (NoConfig,Macro1..Macro36)
Setting of the macro to be associated with blue1 key of Remote Control
BlueKey2Macro (NoConfig,Macro1..Macro36)
Setting of the macro to be associated with blue2 key of Remote Control
Areas
(Area1...Area12)
Setting of area to which Remote Control belong to
For the operation and interaction with the remote control, refer to User Manual Chapter 5.
Procedure of Remote Control Learning
Radio Remote Controls are Bidirectional objects, and must be "learned" by the system
using the following procedure:
1. Verify that the plant is fully functional and that there is at least one radio receiver within
the range of remote control
2. Press all 4 buttons on the remote control at the same time
3. While holding the 4 button LED starts Red Flashing at a frequency of 4 Hz
4. While pressing the 4 buttons after a few seconds the red LED stays lit: at this point you
can release the four keys
5. Press any button on the remote control
6. As a confirmation of successful learning the Green LED will flash 3 times. If not present
a green flashing, make the whole procedure again from step 1.
OK
Install Menu
15)Radio Mod.
Radio Mod.
RadioModule 1
OK
RadioModule 1
Enabled
OK
Install Menu
16) Radio RemCont.
Radio RemCont.
Radio RemCont.1
OK
Radio RemCont.1
Enabled
Summary of Contents for Synergy SY800
Page 1: ...1 ...
Page 60: ...Installer Manual Microvideo srl www microvideo eu 60 ...
