Microvideo Synergy SY800, Instruction Manual

Page: 12 / 69

Installer Manual Microvideo srl www.microvideo.eu
12 Chapter 2 –Modules Description
Report LED D2
OFF No Faults
3 quick flashes at the boot
(100ms On /100ms Off x 3 times at the boot)
End initialization module
100ms On /300ms Off x 3 every 3 sec
SIM900-MCU communication error
100ms On /300ms Off x 2 every 3 sec CAN BUS communication error
Setting the Dip-Switch
We need the dip-switch for future use, so actually it must be configured as in the figure
below:
Expansion Module (Mod. SY840)
The expansion module allows to extend the number of inputs and outputs that the system
can handle.
The model SY840 has 8 inputs, 1 relay, and 3 open collectors. Equipped with tamper
protection that can be turned off as needed by easy tamper.
All inputs of the expansion can be configured as:
- NO, NO Balanced
- NC, NC WB, NC Double Bil Triple Bil
- Blinds
- InsImpImp
- InsImpLiv
All outputs:
- FIXED Output
- SIREN Output
- PULSE Output
Rif SY840
A Tearproof Tamper
B F2: Fuse rapid (2A) to protect the net +12 T outputs
C Tamper Exclusion OFF: EXCLUDED tamper
ON: ENABLED tamper
D Relay: 3A - 24VDC
E Switch for ID configuration
F StatusLED Flashing: Corretto funzionamento
Off: anomalia
G Power LED On: module has power
Off : fault
H F1: rapid fuse (2A) to protect lines +12v of inputs
I Tearproof
Tamper Exclusion Off: excluded tamper
On: enabled tamper
J Tearproof Tamper