Microtronics myDatalogNANOamr, User Manual

Page: 52 / 125

9.2.1.4.3 Alarm
Note: The alarm levels for calculated channels can only be evaluated once the device has transmitted the
measurement data to the myDataweb server.
Alarm low An alarm is initiated if the measurement value drops to or below this value.
Alarm high An alarm is initiated if the measurement value meets or exceeds this value.
Hyst % Hysteresis for all-clear (e.g. hyst = 5%, alarm or warning at 100 -> all-clear at 95)
9.2.1.5 Internal channels
9.2.1.5.1 Basis
Battery title Freely selectable channel title for the battery voltage
Unit
String, which is used as the measurement unit by all of the server
display elements
GSM level title Freely selectable channel title for the GSM level
Unit String, which is used as the measurement unit by all of the server
display elements
9.2.1.6 Alarm settings
Acknowledgement Standard The global server setting is used to determine whether to
acknowledge alarms automatically or manually (see "myDatanet
Server Manual" 805002).
automatic Alarms are acknowledged automatically as soon as all of the
messages have been sent. If SMS that have a tariff with a delivery
confirmation function have also been sent, acknowledgement is
provided after delivery confirmation.
Manual Alarms must be acknowledged by the user.
Offline alarm Alarm in the event that the device does not respond for longer than the set
transmission cycles
Transfer volumes Standard The configuration for the transfer volume alarm is adopted from
the global server setting (see "myDatanet Server Manual"
805002).
Off The transfer volume alarm is deactivated.
Individual The level at which the transfer volume alarm should be triggered
can be entered in the adjacent field in KB.
52 Rev. 01