Microtronics myDatalogNANO Ex, User Manual

Page: 53 / 111

Chapter 8 Initial Start-Up
Chapter 8 Initial Start-Up
8.1 User information
Before you connect the myDatalogNANO Ex and place it into operation, you must observe and
comply with the following user information!
This manual contains all information that is required for using the device.
Is intended for technically qualified personnel who have the relevant knowledge and experience in
the area of measurement technology.
Read this manual carefully and completely in order to ensure the proper functioning of the myDa-
talogNANO Ex .
Please contact our technical department if anything is unclear or if you encounter difficulties with
regard to installation, connection or configuration (see "Contact information" on page 111).
If necessary, please also refer to the manuals of the accessory parts when commissioning the com-
plete system. These manuals are included in the scope of delivery of the accessory parts.
8.2 General principles
The entire measurement system may only be placed into operation after completion and inspection
of the installation. Study the manual thoroughly before placing into operation to prevent faulty or
incorrect configuration.
Utilise the manual to familiarise yourself with the operation of the myDatalogNANO Ex and the input
screens of the myDatanet-Server before you begin with the configuration.
8.3 Commissioning the system
Note: It is recommended that the myDatalogNANO Ex is first placed into operation in the office before mounting the
device permanently at the place of use. During this process, you should set a site for the later operation on the
myDatanet server (see "myDatanet Server Manual " 805002) and determine a site configuration (see "Site con-
figuration" on page 59). Take the opportunity to get to know the functions of the device in a stable environment.
You can also use suitable test signals to simulate the sensors to establish the optimum configuration of the myDa-
talogNANO Ex prior to its actual first use. This reduces the amount of time required for on-site installation to a mini-
mum.
The following work should be completed at the office before you go to the future location of the
device:
1. If necessary, create a customer on the myDatanet server (see "myDatanet Server Manual "
805002).
Rev. 01 53