Microtronics myDatalogGauge 3G, User Manual

Page: 83 / 158

Chapter 10 User interfaces
10.2.1.1.3 Comments
"Comments" configuration section
1 Free comment field (is also displayed below the device type in the site list)
10.2.1.1.4 Measurement channels
10.2.1.1.4.1 Basis
"Measurement channels" configuration section, "Basis" tab
1 Freely selectable channel designation for the fill level that is recorded by means of the BLE Gauge
assigned to the measurement channel
2 Selection of the mode used to assign the BLE Gauge to the corresponding measurement channel
automatic The BLE Gauge , whose serial number has already been stored in the myDatalogGauge
3G during production, should be used to acquire the measurement values.
manual The BLE Gauge , that should be used to acquire the measurement values, is assigned
manually by entering the serial number of the BLE Gauge in the "S/N" field.
Off Measurement channel deactivated
3 Serial number of the BLE Gauge used to acquire the measurement values. Read Only if "automatic"
mode has been selected for the assignment of the BLE Gauge to the measurement channel.
4 Provided to adjust the zero point (see "Additional explanation on the zero point adjustment and
installation height of the pressure sensor" on page 84)
5 Specifies the installation height of the sensor (see "Additional explanation on the zero point adjustment
and installation height of the pressure sensor" on page 84)
6 Selection of the length unit (mm, cm or m) used by all of the server display elements
7 Number of decimal places that are used by all of the server display elements
8 Buttons to switch between the individual tabs of the configuration section
Rev. 01 83