Microtronics myDatalogGauge 3G, User Manual

Page: 149 / 158

Chapter 16 Troubleshooting and repair
16.2.4 Module-specific information regarding the current operating state
Log entry Parameter
Description
Code Plain text Code Plain text
2400 Activation module
has been removed
0 --- The activation modules has been removed from
the sensor recess of the myDatalogGauge 3G .
Activation module
has been inserted 1 --- The activation module has been inserted in the
sensor recess of the myDatalogGauge 3G .
2401 Serial number of first
sensor module
## --- Serial number of the BLE Gauge that is
assigned to measurement channel 1
This entry is always duplicated in the device log.
In the first entry, the parameter specifies the
higher 16Bit of the serial number and the second
entry specifies the lower 16Bit of the serial
number.
2402 Serial number of
second sensor
module
## --- Serial number of the BLE Gauge that is assigned
to measurement channel 1
This entry is always duplicated in the device log.
In the first entry, the parameter specifies the
higher 16Bit of the serial number and the second
entry specifies the lower 16Bit of the serial
number.
2410 Solenoid switch was
released again after
being pressed
0 --- Solenoid switch was released again after being
pressed.
Solenoid switch
pressed 1 --- Solenoid switch pressed
2420 Scan for BLE devices
started
0 --- Scan for BLE devices has been started
2421 Number of scanned
BLE devices
## --- BLE devices were found. The parameter
specifies the number of BLE devices found.
2422 Sensor not
connected, start
search
1 --- Search for the BLE Gauge assigned to
measurement channel 1, was started again as
the cyclic check determined that the connection
to the BLE Gauge is no longer available.
2 --- Search for the BLE Gauge assigned to
measurement channel 2, was started again as
the cyclic check determined that the connection
to the BLE Gauge is no longer available.
Rev. 01 149