14
3.4.4 Fixture Connecting
When connecting the fixture, it is required to discharge the power of Test
Piece thoroughly. Turn the latches on both sides of the fixture to left until
aligning with the small protruding point on the BNC port. Push the fixture
down to the end and then rotate the latch rightward for fixing the fixture.
Next, execute O/C and S/C trimming (See
) and load the
measured Test Piece in-between both locking plates on the fixture. Then
fasten the screws to secure the Test Piece and the measuring process
can be started.
Turn the knob to the right
Insert the fixture FX-00C19
Press the open
correction
Measure the DUT
Press the short
correction
Summary of Contents for 6632 Series
Page 61: ...56 Appendix Z Accuracy Chart...