Operating Instructions Thread tapping units/ Accessoriesr 01/09, Software 4.9
©
01.1994-2016 microtap GmbH
39
SETUP
SELECT
LANGUAGE
ENGLISH
MODE
OK?
>mm<
Fig. 4-3 Setup menu
PROCESS PARAMETERS
NEW
LAST
Fig. 4-4 Basic menu 2
MEGATAP II G8 ZAP
VER.4.9. 19.12.00
PROCESS PARAMETERS
NEW LAST
Fig. 4-2 Basic menu
4. Upon conclusion of the self-test, the basic menu is
displayed
Explanation:
• Line
1
machine type and limit of capacity.
p.e. megatap II-G8 (threads M8 in stainless
steel) and integrated option such as ZAP
• Line
2
software version, date of software
• Line 3 and 4
machine parameters
Selection set of parameter: NEW, LAST
5. Press the selector switch under the word "NEW" if you would like to create a
new program
6. Press the selector switch under the word "LAST" if you would like to work with
the last parameter setting.
7. Version megatap II: Set the drive selector switch to “1”.
8. The machine is now ready for operation in the standard settings.
4.3. System
Setup
1. Turn on the main switch of the operating head
and
at the same time
press and hold the soft
key (7)
RETURN
depressed during the machine
self-test (about 5 seconds), The resulting display
is shown in Fig 4-3.
-
Use the selector key (3) to select the measuring
unit mm or inch.
-
Use the rotary knob and select the language
(German, English, Francais, Netherland,
Svensk, Danish, Italiano).
-
Press the selector to set.
2. The basic menu 2 will appear in the display (see
Fig 4-4).
3. The machine is now ready for operation.
