132
SyncServer 600 Series User’s Guide
098-00720-000 Revision B – April, 2016
Chapter 5
SyncServer S6x0 CLI Command Set
set-session-timeout
Use this command to define a timeout for a CLI session. The session will
auto-terminate if there is no session activity (i.e. user entries) for the configured
duration. If the connection is remote SSH, the connection will terminate upon
timeout. If the session is direct to the CONSOLE serial port, auto-logout will occur
upon timeout.
Command Syntax:
set-session-timeout
– The system will prompt for the timeout value.
Example:
To set the session timeout to one hour (3600 seconds):
SyncServer> set-session-timeout
The system will prompt for the timeout value.
Timeout ( 0 - 86400 sec):
Enter the following, then press Enter.
3600
Response:
3600 sec timeout set succcessfuly
show-session-timeout
Use this command to display the session timeout value.
Command Syntax:
show-session-timeout
Example:
SyncServer> show-session-timeout
Response:
The current session timeout - 3600 sec
