Power Over Ethernet Power View Pro User Guide
Copyright
2013
Microsemi
23
Rev.1.0, 17-Dec-13
Analog Mixed Signal Group
1 Enterprise, Aliso Viejo, CA 92656, USA; Phone (USA): (800) 713-4113, (ROW): (949) 221-7100 Fax: (949) 756-0308
NOTE:
Network traffic to PD devices might be interrupted for several seconds
, without affecting
PoE power.
Reset Unit
– Reset the entire unit including the internal Network Manger, the PoE controller, and the
internal Ethernet Switch.
Restore to Factory Default
– Restore unit configuration to factory default
, leaving IPv4/IPv6 network
configuration unchanged
(as DHCP/Static IP, IP Address, etc.), maintaining the option to access the
unit over the network as before.
NOTE:
To simplify finding the unit over the network, upon power up the unit will send SysLog
broadcast messages (to any SysLog server on the Network) reporting its IP network
configuration parameters, its MAC address, host name, etc.
3.5 Information Web Page
Information Web page provides information on current IPv4 and IPv6 addresses, plus miscellaneous product
information such as software version, PoE firmware version, etc.
Figure 3-15: Information Web Page
