Microscan Visionscape FrontRunner, User Manual

Page: 109 / 152

Using Previously Saved Calibration Data
C
amera
Ca
libration
3
v4.1.3, April 2012 Visionscape FrontRunner™ User’s Manual 3-17
Calibration page, and then selecting the File Will hold Cal Data
for my Entire Job.
Note: You can only reload this data into an Job that has the same
number of Snapshots.
If you select this save option, FrontRunner™ displays the Save
Calibration for Entire Job dialog box. Type in a file name. Click
Save, and then click Finished.
It is important to understand that when Calibration is performed, the
data is stored in the Snapshot step(s) of the Job, so the Job needs to
be saved when done. You do not need to use the Save options on
this page unless you want to load the Calibration Data into another
Job, or unless you want to simply have a back-up.
Using Previously Saved Calibration Data
When calibration is performed, FrontRunner™ stores the data in the
Snapshot step(s) of the Job. This means you must save a Job after
calibration is completed.
You do not need to use the Save options on this page unless you want to
load the Calibration Data into another Job, or unless you want to simply
have a backup.
Use the following procedure to load calibration data that was previously
saved:
1.
Create a new Job or open an existing Job.
2.
Click
FrontRunner™ displays the Calibration dialog box, as shown in
Figure 3–14.