Microscan Quadrus Verifier, User Manual

Page: 418 / 470

A-4
Quadrus Verifier User’s Manual
Electrical Specifications
Appendix B — Electrical Specifications
Power Requirements: Input, 10 to 28 VDC, 200 mV p-p max ripple,
333 mA at 24 VDC
Trigger, New Master, Input 1: (Optoisolated) 5 to 28 VDC rated (12
mA at 24 VDC)
Outputs 1/2: (Optoisolated) 1 to 28 VDC rated (I
CE
< 100 mA at 24
VDC, current limited by user)
Output 3: Light control (Optoisolated) 1 to 28 VDC rated (I
CE
< 100
mA at 24 VDC, current limited by user)
Quadrus Verifier Host 25-Pin Connector
Pin
Host
RS-232
Host and Aux RS-232 Ethernet I/O
1 Chassis Ground
a
a. Chassis Ground: Used to connect chassis body to earth ground only. Not to be used as power or
signal return.
2 TxD Out
3 RxD In
4 RTS TxD Out
5 CTS RxD In
6 Output 1 (+) Out
7 Signal Ground
b
b. Signal Ground: Used for communication and signal line grounds only. Not to be used as power or
chassis return.
8 Output 2 (+) Out
9 Trigger (-) In
10 Trigger (+) In
11 Default Configuration
c
c. The default is activated by connecting pin 11 to ground pin 7.
In
12 Input 1 (+) In
13 RxD (+) In
14 RxD (-) In
15 Light Control (+) Out
16 TxD (-) Out
17 Power Ground
d
d. Power Ground: Used for power return only.
CAUTION: If using your own power supply, verify correct connection of power and ground lines.
Incorrect connections or use of Chassis Ground, Power Ground, and Signal Ground lines could
equipment failure or software failure.
18 Power + 10 to 28 VDC In
19 TxD (+) Out
20 Output 1 (-) Out
21 Output 2 (-) Out
22 Light Control (-) Out
23 Input 1 (-) In
24 New Master (-) In
25 New Master (+) In
25-Pin Connector