Microscan Quadrus Verifier, User Manual

Page: 273 / 470

Quadrus Verifier User’s Manual
8-33
I/O Parameters
Load New Master
Functions the same as new master pin input whenever the associated button position is selected.
The new master pin’s
Consecutive Decode requirement holds true for this function.
Target System
Turns on the targeting system (target pattern) whenever the associated button position is
selected. To disable, quickly press and release the
EZ button.
Note: This mode is the only one that does not require that the button be released before
taking effect. Thus, as soon as the Verifier beeps the appropriate number of times for the
position, it will take effect. If it is necessary to have the target system on before another
operation such as calibration or read rate is performed, ensure that the target system
mode is assigned a lower position so that it will be activated first.
Live Video
Enables live video mode when the associated button position is selected. To disable,
quickly press and release the
EZ button.
Important: If the user has a non-video unit and this mode is selected, it will behave the
same as if the mode was disabled.
Bar Code Configuration
Enables bar code configuration mode whenever the associated button position is selected.
When enabled, the reader can accept configuration commands from symbols. To disable,
quickly press and release the
EZ button.
EZ Button Operation
To execute EZ button commands,
Single Beep (Position #1)
Hold down button until a singe beep is heard (and the 20% LED illuminates).
Two Beeps (Position #2)
Hold down button until two quick beeps are heard (and the 20% and 40% LEDs illuminate).
Three Beeps (Position #3)
Hold down button until three quick beeps are heard (and the 20%, 40% and 60% LEDs
illuminate).
Four Beeps (Position #4)
Hold down button until four quick beeps are heard (and the 20%, 40%, 60% and 80%
LEDs illuminate).