Setup Menu
MS-850 Raster Scanner User’s Manual
2-39
2–Menu C
o
n
fig
.
No Barcode Output
Default:
Disabled
Options:
Disabled, Enabled
Allows you enable or disable the no label message.
No Barcode Message
Default:
NOLABEL
Options:
Up to seven ASCII characters (except NUL)
Allows you to define the message that is sent when an object is present without a
label.
Bad Barcode Output
Default:
Disabled
Options:
Disabled, Enabled
Allows you enable or disable the no label message.
Bad Barcode Message
Default:
BADCODE
Options:
Up to seven ASCII characters (except NUL)
Allows you to define the message that is sent when a label is defective.
Factory Settings
You can change and save certain factory settings to non-volatile memory for power-on
the scanner. Factory Settings applies only to Gain Adjustment and Scanner Type.
Caution
: Changing this setting can adversely affect the quality of the MS-850
decodes. Keep a record of these settings in case you need to restore them later.
So that your factory settings will not be changed and saved accidentally, the actual
save function is carried out in the Send/Receive Dialog box.
Gain Adjustment
Default:
45
(nominal)
Options:
10 to 255
Note
: Gain Adjustment is optimized at the factory before shipment; your default
value may not be 45.
Allows you to specify a gain value for the analog circuitry. Changes to Gain should
typically be done by qualified technicians.
IMPORTANT
: Before saving any changes to Gain Adjustment (see “Save Scanner Type,
SPS, and Gain for Power-on”, first record the optimized factory setting for future reference.
