Microscan MS-810, User Manual

Page: 7 / 144

MS-810 Scanner User’s Manual
ix
Approvals
This equipment is designed for approval or compliance by the following organiza-
tions:
• CDRH (Center for Devices & Radiological Health)
• UL (Underwriters Laboratories, Inc.)
• cUL (UL mark of Canada)
• TüV (Technischer überwachungs-Verein)
• FCC (Federal Communication Commission)
• CE Compliant
Warning and Caution Summary
This equipment has been tested and found to comply with the limits for a Class A
digital device, pursuant to part 15 of the FCC Rules. These limits are designed to
provide reasonable protection against harmful interference in a residential installa-
tion. This equipment generates, uses, and can radiate radio frequency energy, and,
if not installed and used in accordance with the instructions, may cause harmful
interference to radio communications. However, there is no guarantee that interfer-
ence will not occur in a particular installation. If this equipment does cause harmful
interference to radio or television reception, which can be determined by turning the
equipment off and on, the user is encouraged to try to correct the interference by
one or more of the following measures:
• Reorient or relocate the receiving antenna
• Increase the separation between the equipment and receiver
• Connect the equipment into an outlet on a circuit different from that to which the
receiver is connected
• Consult the dealer or an experienced radio/TV technician for help
This appliance can only be connected to a VDE approved power supply with a rating
voltage between 10 V DC and 28 V DC. The SELV power supply must be rated at
least 6,5 W at the output to avoid any hazard.
European models must use a similarly rated Class I or Class II power supply that is
certified to comply with standard for safety EN 60950.