Microscan MS-810, User Manual

Page: 50 / 144

Chapter 2
2-28
MS-810 Industrial Scanner User’s Manual
2–Menu Conf
ig
.
Interleaved 2 of 5
Default: Disabled
Options: Disabled, Enabled
Because I 2 of 5 is a continuous code, it is prone to substitution errors. Hence, a code
length must be defined and a bar code label containing an even number of digits must
be used. It is also recommended that a Modulus 10 check digit be used to ensure the
best possible data integrity.
Check Digit
Default: Disabled
Options: Disabled, Enabled
I 2 of 5 uses a Modulus 10 check digit.
Check Digit Output
Default: Disabled
Options: Disabled, Enabled
When enabled, the check digit character is sent along with the label data. When dis-
abled, label data is sent without the check digit.
Code Length #1
Default: 10
Options: 0 to 64, even. If you enter an odd number the scanner will use the next
lower number.
With I 2 of 5, two code lengths can be defined. When using only one label length in an
application, we recommend setting Code Length #2 to 0 to ensure data integrity. If a
check digit is used, it must be included in the code length count.
Code Length #2
Default: 6
Options: 0 to 64, even. (If you enter an odd number the scanner will use the next
lower number.)
If using a second label, you may also specify a zero or any even code length from 2 to
30. If not using a second label, set Code Length #2 to 0 to ensure data integrity.