Microscan MS-710, User Manual, Page: 151 / 186

Appendices
MS-710 Scanner User’s Manual
A-11
Appendix
Appendix D — Serial Configuration Commands
The following table is a list of all the available serial configuration commands (also
called “K commands”). These commands are also listed at the beginning of each appli-
cable chapter. For utility (operational) commands see Table 9-1, “Summary of Utility
Serial Commands,” on page 9-3.
Table A-7 Complete List of Serial Configuration Commands
Command Title Format
COMMUNICATIONS
Host Port Connections < Ka baud,parity,stop bits,data bits>
Host Protocol
< Kf protocol>
Auxiliary Port
< Ky aux port mode,baud,parity,stop bits,data bits,daisy chain sta-
tus,daisy chain ID>
Preamble < Kd status,preamble>
Postamble < Ke status,postamble>
LRC < Kc status>
Response Timeout < KA response timeout>
Intercharacter Delay < KB intercharacter delay>
READ CYCLE
Multisymbol < KL number of symbols,multisymbol separator>
Trigger Mode < Kg trigger mode,filter time>
External Trigger State <
Kj external trigger state>
Serial Trigger Character < Ki serial trigger character>
End of Read Cycle < Kh end of read cycle,read cycle timeout>
Good Decode Reads < Km good decode reads>
Scan Speed < KE scan speed>