Microscan MS-710, User Manual, Page: 102 / 186

Serial Verification
6-14
MS-710 Scanner User’s Manual
6–I
/0 Param
e
te
rs
Serial Command Beep Status
Important: ESP will not function whenever this command is enabled.
Control/Hex Output
Usage: Used to audibly verify the acceptance and validity of a command.
Definition: Causes the scanner to beep once whenever a K command is entered to
indicate that the command was accepted and processed.
Function: If an invalid command is entered, the scanner beeps 5 times to indicate
an invalid entry. However, this does not necessarily mean that all data
fields have been entered incorrectly. Only one bad field needs to be found
in order to activate the 5 beep response.
Serial Cmd: < KS serial command echo status, serial command beep status ,control/
hex output>
Default: Disabled
Options: 0 = Disabled 1 = Enabled
Usage: Used for viewing settings with binary characters when using serial com-
mand on a terminal.
Definition: Determines the response to a Serial Command Echo or status request
command.
When set to
Control, two characters are transmitted to represent a non-
displayable character. For example, a carriage return will be shown as the
two characters: ^M .
When set to Hex, the output is the hex character.
Serial Cmd: < KS serial command echo status,serial command beep status, control/
hex output >
Default: Control
Options: 0 = Control 1 = Hex