Updating the Firmware with the Bootloader
Updating Firmware on
1600T Cameras
E
Rev. 1G, Dec 2008
HawkEye™ 1600T Smart Camera Guide
E-3
Updating the Firmware with the Bootloader
If power is lost while the Smart Camera Update is in progress, the Smart Camera
will not boot when power is restored. When this occurs, you will need to use the
Bootloader application in Non-Volatile memory (which is not erased by the
Smart Camera Update utility) to update the firmware.
Use the following procedure to update the firmware on your HawkEye™ 1600T
Smart Camera with the Bootloader:
1.
Start a HyperTerminal session with the following settings:
FIGURE E–2.
COM1 Settings
2.
Click
OK
.
3.
While you hold down the Escape key, cycle power on the HawkEye™
1600T Smart Camera. Information similar to the following is displayed:
HawkEye Smart Camera
400MHz 16MB Flash 64MB RAM
-----------------------------
Name: HawkEyeE1000E
Static IP: 161.218.121.183
Summary of Contents for HawkEye 1600T
