MicroPower SC17-32 24 V, Manual

Page: 5 / 206

CAUTION, undesirable conse-
quences
. The situation needs
operator awareness or action.
For indoor use only . The battery
charger is designed only for indoor
use unless the charger is at least
IPX4-rated.
Well-ventilated . Always provide
proper ventilation during charging.
WARNING, explosive gases .
Lead-acid batteries generate
explosive gases during charging.
No open flame . Fire, open ignition
source and smoking are prohibited
near battery.
Introduction
This document contains use and maintenance
instructions for the intended battery charger.
This document is of relevance for the one who
uses the battery charger for its purpose; charge
batteries. It includes connecting the charger to the
battery, handling the charging process, and
managing basic settings.
Target groups:
• Installers
• Operators
• Maintenance personnel and technicians
Receiving
On receipt, visually inspect the product for any
physical damage. If necessary, contact the
transport company.
Check the delivered parts against the delivery
note. Contact your supplier if something is
missing, see
Contact information .
Installation
Mechanical installation
Install the battery charger indoors in a
dry, clean and well-ventilated environment, unless
the charger is at least IPX4-rated. Comply the
dimensions specified for free space around the
battery charger, see
Fig. 2 Installation .
1. Install the battery charger so that gases from
the battery charging process are not sucked in
by the battery charger fans.
2. Attach and secure the battery charger to a
wall with screws (not included).
CAUTION
The battery charger should always be securely
fastened.
Electrical overview
See figure Fig. 3 Connections and components :
1. Negative terminal (−).
2. Positive terminal (+).
3. Fuse, for specifications see
Fuse protection .
4. Circuit board connector for option cable
signals (see below).
Option cable signals
If option cable signals are to be used, it is
recommended to first make wire connections
separately on the connector and then plug the
connector to the socket on the circuit board, see
Fig. 4 Option cable, signal pinout . For further
information contact service personnel.
Electrical installation
WARNING
High voltage!
Incorrect connection of battery cables can cause
personal injuries and damage to the battery,
battery charger and cables.
Make sure the connections are correct.
WARNING
High voltage!
Risk of live chassis.
Always connect the charger to a power outlet with
protective earth.
1. The battery charger is produced for different
mains voltages. Check that the power supply
at the site of the installation complies with the
ENGLISH
5