Micromeritics AccuPyc 2 1340, Operator'S Manual, Page: 50 / 158

System Commands AccuPyc II 1340
3-16 Aug 2013
This prompt enables you to select the printer you wish to use
for generating reports. This is a system option and does not
have to be specified for each analysis (or calibration). It also
applies for all units when multiple analysis modules are
attached.
Choices: Canon Bubble Jet, Epson ESCP, Epson ESCP2,
Epson ESCP Raster, HP PCL 3, HP PCL 6XL,
PostScript
Refer to SUPPORTED PRINTERS , page G-1 for
information on the printers supported by the AccuPYC.
Press CHOICE to select the appropriate printer, then press
ENTER
.
Select the format of data to be used when transmitting
reports. Refer to
TRANSMITTED DATA , page D-1 for the
format used when transmitting data.
Choices: Single column, Spreadsheet
Press
CHOICE
to select the format, then press
ENTER
.
Prompts for a MultiVolume insert during analysis or calibra-
tion operations.
Choices: Yes or No
An insert is a device you can place in your sample chamber,
allowing you to use a smaller sample cup for analysis of
smaller sample quantities. Inserts are available in MultiVol-
ume Kits for the 1.0-, 10-, and 100-cm
3
pycnometers. Refer
to ORDERING INFORMATION , page 6-1 for informa-
tion on placing an order.
If you are not using MultiVolume inserts, ensure that No is
selected, then press
ENTER
.
Unit[n] SN1234 10 cm3
Report Options
Printer?
Epson ESCP2
Unit[n] SN1234 10 cm3
Report Options
Transmission Format?
Single column
Unit[n] SN1234 10 cm3
Report Options
Request insert?
No