Micromeritics AccuPyc 2 1340, Operator'S Manual

Page: 44 / 158

System Commands AccuPyc II 1340
3-10 Aug 2013
value (when applicable). To use the default value, just press ENTER . For example, when you press Alt
+ 2
, the following prompt is displayed:
To select Analysis Parameters , which is the default option, press
ENTER
.
If you do not wish to use the default option, you can use the keypad to enter or choose other responses.
There are two types of prompts:
• Data entry prompts are followed by a colon (:). Use the keypad to enter the desired
value, then press
ENTER
. If you enter an value that is out of range, you will hear a beep
and a message showing the range is displayed; enter a value in the range displayed.
Unit[n] SN1234 10 cm3
X - X - X
Setup Type?
Analysis Parameters