microHAM © 2010 All rights reserved
Configuring microHAM USB Device Router
The microHAM USB Device Router (Router) program provides a Windows compatible configuration tool for
microHAM USB Devices (microKEYER II as well as DIGI KEYER, microKEYER, CW Keyer and USB
Interfaces) and software interface to other Windows applications (logging software, digital mode software,
etc.). The software interface is provided as Virtual Serial Ports.
In order to configure and use microKEYER II with Windows compatible application programs, you must be
running Router and have turned on microKEYER II. Router is then configured as required by the
application (logging, control or digital mode) software.
microKEYER II Status
When the USB driver is installed correctly and microKEYER II is
turned on Router will show a device tab with a GREEN check
beside the device name.
When Router shows a YELLOW “X” instead of a green
, it
means the USB driver is correctly installed but microKEYER II is
not turned on.
When Router shows a RED “X” instead of a green
, it means the
device is disconnected and Router does not see the USB part of
microKEYER II. This happens when the USB cable is unplugged
or the USB driver is not correctly installed.
Initial Setup
Router must be used to configure microKEYER II for proper operation. The device configuration tabs (in
the red rectangle) are used to setup each part of the microKEYER II.
12
