...........continued
Electrical Parameter
Value
Maximum 3.3 VDC current
300 mA
CAUTION
The SAMA7G54-EK board runs at a 3.3V voltage level logic. The maximum voltage that the I/O pins can
tolerate is 3.3V. Providing higher voltages (e.g. 5V) to an I/O pin could damage the board.
2.5
On-Board Connectors
The fully-featured SAMA7G54 Evaluation Kit integrates multiple peripherals and interface connectors, as shown in
the following figure.
Figure 2-1. SAMA7G54-EK Connectors
J-Link-OB
Micro-AB
JTAG 20-pin
IDC Connector
3 x User Buttons
MIPI CSI Camera
Connector
Disable
Boot
Button
UART DEBUG
External
Power
Jack
2 x CAN
Connector
USB 2.0
Micro-AB
USB Host
Type-C
USB Host
Type-A
SD Card
Connector
Footprint to
solder the
WiFi/BT
Module
WiFi/BT
Debug
Connector
SPD
IF
RX
Connector
SPD
IF
TX
Connector
Ethernet 10/100
Gigabit Ethernet
Disable
Boot
Jumper
mikroBUS Connector
Raspberry Pi Connector
mikroBUS Connector
WiFi/BT
Table 2-4. SAMA7G54-EK Board Interface Connectors
Connector
Interfaces To
J1
External power jack
J4
Standard SDMMC connector
J5
Gigabit Ethernet RJ45
J6
Ethernet 10/100 RJ45
SAMA7G54-EK
Product Overview
©
2022 Microchip Technology Inc.
and its subsidiaries
User Guide
DS50003273A-page 5
