2020 Microchip Technology Inc.
DS50002997A-page 20
PLECS MODEL
QUICK START GUIDE
FOR VIENNA PFC
Chapter 6. Modifying Control Parameters
and Component Values
At the start of simulation, PLECS executes the initialization commands under the
Simulation Parameters Initialization tab. The variables are available as global variables
to components and subsystems. It also executes the initialization commands contained
in the mask of each subsystem. Variables defined in a mask are local to the subsystem.
These variables cannot be modified after the simulation starts.
To edit the mask, right-click the subsystem and select Edit mask as shown below or by
Ctrl+M. Then, select the Initialization tab.
FIGURE 6-1:
Editing the Mask.
FIGURE 6-2:
Mask Editor.
