This is the setting for the Syslog facility number. It represents the “Local Use” value range 0 to 7 (i.e. Facility
Number range 16 to 23).
Enter the Facility Number of the Syslog subscriber.
5.
Repeat Steps 2-4 for Each Additional Subscriber
Click 'ADD' again to add another Syslog subscriber, click on the '02' tab under the 'ADD' button to navigate to
the new Syslog subscriber settings. The '01' tab contains the settings for the subscriber that was previously set
up.
Repeat for as many subscriptions as are present on the network.
Tip:
Click the red bin icon to remove a Syslog subscription.
6.
Save Settings
Click the 'SAVE' button to write the settings to the GridTime 3000.
A 'Saved!' notification will appear in the bottom right corner of the page indicating that the settings have
successfully been written to the GridTime 3000.
9.12.3
Provisioning SNMP Users
This section describes how to provision SNMPv3 USM users.
Note:
Only an 'Administrator' user can configure SNMP Users on the GridTime 3000
1.
Navigate to SNMP Users Tab
Click on the 'Settings' icon in the bottom left corner of the CMT's sidebar.
Provisioning
©
2022 Microchip Technology Inc.
and its subsidiaries
Manual
DS00004572A-page 201
