Getting Started
2009 Microchip Technology Inc.
DS70605A-page 15
FIGURE 2-3:
dsPICDEM™ MCHV DEVELOPMENT SYSTEM (LEFT SIDE)
FIGURE 2-4:
dsPICDEM™ MCHV DEVELOPMENT SYSTEM (RIGHT SIDE)
2.3
CONNECTING THE SYSTEM
2.3.1
Power Connections
It is recommended that cables used for the power connections should be terminated
with blue or red insulated crimp terminals. If crimp terminals are not used, care should
be taken to ensure that stray strands of wire do not short to adjacent terminals or the
enclosure. If possible, all wires should be stripped and tinned with solder before
connecting to the dsPICDEM™ MCHV Development System terminals.
CAUTION
The user must be aware of the operating procedures outlined below and ensure that
they are followed. Failure to do so may result in damage to the system.
J1
3-Phase Inverter
Bridge Connector
Hall Sensors/
QEI Connector
