26
/
32
3
）
Unplug the power control cable on the control panel, remove the power supply, and
remove the power supply
：
8.2.2.Power Supply Installation
1
）
First plug the control cable of the power supply into the corresponding slot on the
control panel, as shown below
：
2
）
Then connect the 6 positive and negative terminals on the power supply to the
copper row one by one, and then install 6 screws in turn. The screws should be tightened
and the gasket should be aligned parallel to the edge of the copper bar to avoid short
circuit burning the power supply or the power board, as shown below
：
