14
must be connected. Otherwise, the power supply voltage output may not be
controlled, resulting in low power calculation.
（
3
）
The control board must be connected to the fan wiring reliably. If the fan wiring
is disconnected or the connection is poor, the miner may not be able to cool down, the
power board is down-converted, and the power is reduced.
5.Miner Data Configuration
（
Configuration on
the web page
）
5.1.Query the dynamic IP address obtained by the miner
5.1.1.Run WhatsMinerTools software
Miner data configuration PC Connect to the same network segment network where the
machine is located, run WhatsMinerTools software on the PC, select the “Detect IP” tab,
set the room number, rack number and layer number of the rack where the mining
machine is located. , the location number of the layer, click "Start".
5.1.2.Check the IP address Reported by the Miner
（
1
）
After the machine is powered on for about 30s, under normal circumstances, the
yellow light of the network port is always on and the green light is blinking. Press the
IPFOUND function button (long button highlighted) on the miner control panel for more
than 5s, the two LEDs on the right will flash a few times, indicating that the machine has
broadcast the IP and MAC address of the unit to the network.
