WARNING
: Users of Micro-Robotics Control Equipment should be aware of the possibility of a system failure, and must consider the
implications of such failure. Micro-Robotics Ltd. can accept no responsibility for loss, injury, or damage resulting from the failure of our
equipment. Use of our products in applications where their failure to perform as specified could result in injury or death is expressly
forbidden.
Copyright 2002-2006 Micro-Robotics Ltd
tel: +44 (0) 1223 523100
The Old Maltings
fax: +44 (0) 1223 524242
135 Ditton Walk
Cambridge
www.microrobotics.co.uk
CB5 8QB
Doc D041 V20090119
VM2 Breakout Board
Page 1 of 3
VM2 Breakout Board
5905
VM2 Breakout Board
Introduction
The 5905 Breakout Board for the VM2 Controller provides interfaces to the VM2’s first RS232 serial port; the
first I
2
C bus, and a regulated supply voltage. All of the VM2’s connector pins are taken out to two prototyping
areas so you can prototype your VM2 application.
I2C Bus 1
Prototype Area:
Groups of 6 pads connected with cuttable tracks.
0.1" Grid, 2mm pads, 1mm hole, Plated through.
Indication of grouping on silk screen.
4 off 3.5 mm holes on
142 x 92 mm rectangle.
Reg
Power
VM2
Serial
Size - 150 x 100mm
Reset
P
ro
g
M
o
d
e
D
e
fa
u
lt
C
o
m
U
p
lo
a
d
O
S
[n
c]
V
C
C
G
N
D
S
C
L
S
D
A
S
e
ri
a
l I
C
S
o
ck
e
t
E
E
P
R
O
M
S
o
ck
e
t
Unpacking
You should have:
•
5905 Breakout Board
•
Power Connector
•
These instructions
