Page 42
Software TIM Connect
thermoMETER TIM 8 / thermoIMAGER TIM 40
9.3
Autonomous Operation thermoMETER TIM 8
A special feature of the thermoMETER TIM 8 is the autonomous operation. There is no need for a permanent
connection to the TIM Connect software. Only a few settings must be set in advance in the software.
To do this, connect the PIF and USB cables to the device.
Then connect the thermoMETER TIM 8 to your PC and start the TIM Connect software
, the camera so that your object to be measured is perfectly visible in the im-
age.
First define the desired measurement area with the corresponding mode you want to output.
TIM 8
Fig. 21 Connection thermoMETER TIM 8 to PC via USB
Now go to the configuration menu on Device (PIF).
There you first select the PIF type (in this case: Internal PIF). Then select under Analog Outputs (AO) the
function that is to be output autonomously.
Then press
Setup
, make your settings and make sure that the checkbox is set to using autonomously by
device.
By pressing the
OK
button an @ sign can be found in the configuration menu Devices (PIF), which indicates
the autonomous operation.
