Page 34
Appendix | GenICam surfaceCONTROL Parameters
surfaceCONTROL 3D SC2500 / SC2510
A 3
GenICam surfaceCONTROL Parameters
Details about setting the parameters are available in the software description, see 3D-View operating instructions.
Parameter Description
Observe the notes below if you operate the sensor with a third party library for GenICam/GigE Vision:
-
The library must support GigE Vision 2.1. In particular,
MultiPart
mode must be supported.
-
Three sources are available to set the parameters of the sensor, see the
SourceSelector
description below. Howev-
er, data are always transmitted using
StreamChannel 0
. Before starting data transmission with the
Acquisition-
Start
command, the entry
Source0
must be selected as
SourceSelector
.
-
The network card used should be configured as follows:
Jumbo frames: enable/use largest possible value
Interrupt moderation: enable
Interrupt moderation rate: adaptive
Receive buffer: use largest possible value
-
The
Coord3D_C32f
pixel format is used for 3D measurements. If this pixel format is not supported by the library
used, the
Mono16
pixel format can be used as an alternative. In that case, however, the resolution or measurement
area is limited.
-
The operating mode and sensor data transmitted are controlled using the parameter
ComponentEnable
and the
associated selectors
SourceSelector
,
RegionSelector
and
ComponentSelector
, as well as via
TriggerMode
and
TriggerSoftware
. The following modes are possible, among others:
Setup operation (continuous transmission of raw images):
TriggerMode = Off
ComponentEnable [Source1][Region0][Intensity] = 1
ComponentEnable [Source2][Region0][Intensity] = 1
Set all other selector combinations for ComponentEnable to 0
SourceSelector = Source0
Command AcquisitionStart
-
Measuring operation 3D (triggered continuous 3D measurement):
TriggerMode = On
TriggerSource = Software
ComponentEnable [Source0][Scan3dExtraction0][Range] = 1
If you want a mask image for invalid points:
ComponentEnable [Source0][Scan3dExtraction0] [Confidence] = 1
Set all other selector combinations for ComponentEnable to 0
SourceSelector = Source0
Command AcquisitionStart
Trigger any number of measurements by using command
TriggerSoftware
The parameters marked
Locked
cannot be changed when data transmission is active.
Summary of Contents for surfaceCONTROL SC2500
Page 4: ...surfaceCONTROL 3D SC2500 SC2510...
Page 41: ......
