Page 54
Liability for Material Defects
scanCONTROL 25xx
9.
Liability for Material Defects
All components of the device have been checked and tested for functionality at the factory. However, if de-
fects occur despite our careful quality control, MICRO-EPSILON or your dealer must be notified immediately.
The liability for material defects is 12 months from delivery.
Within this period, defective parts, except for wearing parts, will be repaired or replaced free of charge, if the
device is returned to MICRO-EPSILON with shipping costs prepaid. Any damage that is caused by improper
handling, the use of force or by repairs or modifications by third parties is not covered by the liability for mate-
rial defects. Repairs are carried out exclusively by MICRO-EPSILON.
Further claims can not be made. Claims arising from the purchase contract remain unaffected. In particular,
MICRO-EPSILON shall not be liable for any consequential, special, indirect or incidental damage. In the inter-
est of further development, MICRO-EPSILON reserves the right to make design changes without notification.
For translations into other languages, the German version shall prevail.
10.
Service, Repair
If the scanCONTROL 25xx is defective:
- If possible, save the current sensor settings in a parameter set,
see Configuration Tools, menu
Parameters > Save param-
eters to file...
, in order to load the settings back again
into the sensor after the repair.
- Please send us the effected parts for repair or exchange.
In the case of faults the cause of which is not clearly identifiable,
the whole measuring system must be sent back to:
MICRO-EPSILON Optronic GmbH
Lessingstraße 14
01465 Dresden - Langebrück /
Germany
Tel. +49 (0) 35201 / 729-0
Fax +49 (0) 35201 / 729-90
www.micro-epsilon.com
Summary of Contents for scanCONTROL 25 100 Series
Page 1: ...Operating Instructions scanCONTROL 25xx ...
Page 6: ......
